¶ Unboxing Guide
¶ 1.Unboxing and Removal
（1）Take out accessory box 1
（2）Remove the top foam
(3)Remove packing air pillows
(4)Remove all protective film
(5)Take out accessory box 2
¶ 2.Install Four Rubber Feets
Rubber feet reduce the vibration of the machine.
¶ 3.Plug in Power Cord
Please press the power button after plugging in the power cord.
¶ 4.Cut the Ties
Be careful not to cut the belt.
Please note that the z-axis optical axis has four ties.
¶ 5.Remove the Four Screws
Please note that if the four screws are not removed, the platform will not move.
¶ 6.Remove the Foam
Please clean the foam at the bottom and the ties above the platform.
¶ 7.Click on Auto-leveling
Preheat build bed to 60 degrees.
Please level at the middle point, a little friction is needed between the nozzle and the platform.
Wait for auto-levelling to complete.
¶ 8.Install filament and load
(1)Install filament holder
(2)Insert the filament into the ptfe tube
(3)Preheat the extruder to filament melt temp and load the filament
